Your Own Camoclad Style

The only limit is your imagination! Camoclad Truck Accent Kits come in a variety of sizes and all 15 camo patterns. So there's a kit to suit any application and style. You just have to decide if you want to go mild, wild, or somewhere in the middle. There is no right or wrong. It's your truck! So make it the way YOU want it.

Maybe you want your effect to be subtle - perhaps a classy rocker panel accent to add a touch of rugged distinction. Or maybe you want to make a bold statement and clad the entire center contour. Maybe you have some creative ambitions for a truly radical scalloped look. It's up to you!

Either way, your Camoclad truck will be unique - one of a kind. So whether you go mild, wild, or somewhere in-between, everyone is going to know YOUR truck when they see it.......as they should!

So where do you begin?

The first step is to measure your truck. Accent material comes in long "strips". So you'll just need two basic measurements: how long the strips need to be and how wide they'll need to be.

LENGTH: The Camsoclad accent material comes in 30' or 40' total lengths. Half goes on one side of the truck, half on the other. For a short-wheel base truck (Jeep, Ranger, S-10, Compact SUV, etc.) the 30' kit will likely be enough. For longer wheel base vehicles (Full Size Pick-Ups, Suburbans, Expeditions, Denalis, etc.) the 40' length will probably be required. But to know for sure, you should measure before you order your Camoclad. EXAMPLE: You intend to do a rocker panel accent and the total length along the side of the vehicle is 18 ft. In this case, you'll need roughly 36' of material. So you'll need to order the 40' length accent kit.

WIDTH: Camoclad accent material is available in widths of 8", 11.5", 15", and 23". The correct choice will depend on the width of the area where you want to install it. For example, if you want to add Camoclad from the lower door molding down (like the white truck pictured left), you'll need to measure the distance from the molding to the bottom of the door or rocker panel. Find the widest point and then add 2" to allow for trimming and folding around door edges. You can always trim away a small amount of excess, but you can't stretch a short piece to make it fit. So if in doubt, order the larger size. If you intend to install your Camoclad between body contour lines or effect panels(like the black truck at left), you'll need to measure the widest point between those two contour lines and again add 2".

SPECIAL NOTE: Large or scalloped accents (like the Black Bronco on the left) may require using standard half-sheets (2.5' x 4') rather than accent strips. If your width exceeds 21", you may want to consider using the larger half sheets (30" wide). Order half sheets below.

How to Order

Once you have your measurements, you're ready to order. You can choose your accent kit in any of the 20 popular camo patterns and choose from the 8 available sizes or half-sheets:

8" x 30' Camoclad Truck Accent Kit

8" x 40' Camoclad Truck Accent Kit

11.5" x 30' Camoclad Truck Accent Kit

11.5" x 40' Camoclad Truck Accent Kit

15" x 30' Camoclad Truck Accent Kit

15" x 40' Camoclad Truck Accent Kit

23" x 30' Camoclad Truck Accent Kit

23" x 40' Camoclad Truck Accent Kit